Optional Equipment; Rear Blower Installation - Lopi Patriot Owner's Manual

These wires pass
through the left side
convection channel.
Thermodisk
Assembly
Snap Disk
Wires
Attach the quick-connects
a
leading from the snap disk to the
quick-connects from the blower
(orientation does not matter).
Bend metal up or down
here to create a snug fit
Use a screwdriver to
pry out the knock-out.
Slide the wire clip
over the edge of the
strip of metal between
the two knock-outs.
Wire Clip
The blower attaches to the stove with the three
b
included screws. Use a 3/8" socket driver or wrench.
Plug the power cord into a 110 V. outlet after installing the
c
blower.
Air
Control
Rod
Insert the thermodisk
assembly 4" to 5" inside
the convection channel.
Feed the two snap disk wires into
the eye of the wire clip. Remove
all slack from the wire, making
sure not to dislodge the snap disk.
Pinch the eye of the wire clip to
secure the wires.
WARNING:
To prevent electrical shock, the
wires must be secured so they do
not contact the firebox above the
convection channel.
3/8" Nutdriver
NOTE:
Prior to attaching the blower,
tuck all excess wire into the
area inside the blower.