SERVICING YOUR GENERATOR
3.
Remove the three 6 mm flange bolts, and remove the exhaust tail
pipe and the spark arrester.
EXHAUST TAIL PIPE
6 mm FLANGE BOLT
4.
Use a brush to remove carbon deposits from the spark arrester
screen.
Be careful to avoid damaging the screen.
The spark arrester must be free of breaks and holes. Replace the
spark arrester if it is damaged.
5.
Inspect the screen for breaks or tears and replace it if necessary.
6.
Install the spark arrester and the exhaust tail pipe in the reverse
order of removal.
TORQUE:
8 lbf·ft (11 N·m , 1.1 kgf·m)
7.
Install the muffler protector and the rear bar in the reverse order of
removal.
TORQUE:
6.3 lbf·ft (8.5 N·m , 0.87 kgf·m)
56
6 mm FLANGE BOLTS
SPARK ARRESTER