Alternate Use Of The Water Rainbow As A Fill Spout - Jacuzzi Platinum 2001 Owner's Manual

Alternate Use of the Water Rainbow as a Fill Spout

You can use your Water Rainbow as a fill spout by permanently plumbing it to a fresh water
supply if local codes permit. Local plumbing codes may require the use of an anti-siphon
valve for such a connection. Do not interconnect water supply with recirculating system
of the hot tub.
To make the connections necessary to use the Water Rainbow as a fill spout, follow this
procedure:
Turn OFF circuit breakers at the main electrical panel and drain the hot tub completely.
Unscrew the spout from the 3/4" pipe.
Cut the 3/4" piping as shown in the illustration below.
Cap the piping by cementing a 3/4" PVC cap where the cut has been made.
Connect permanent plumbing line to the spout.
SAVE FOR LATER
REINSTALLATION
(IF DESIRED)
Product specifications are subject to change without notice.
Use installation instructions supplied with this product.
WATER RAINBOW SPOUT
SPA SHELL
INSTALL AND CEMENT
1-1/2" to 2"
3/4" PVC CAP HERE
CUT PIPE HERE
SUGGESTED MODIFICATION
(REFER TO LOCAL CODES FOR
REQUIREMENTS)
TEE LOCATED ON
DISCHARGE
PIPING
Page 43