Alternate Use Of Water Rainbow - Jacuzzi Laser Owner's Manual

Alternate Use of Water Rainbow

You can use your Water Rainbow as a fill spout by permanently plumbing it to a fresh water supply if local codes
permit. Local plumbing codes may require the use of an anti-siphon valve for such a connection. Do not interconnect
water supply with recirculating system of the spa.
To make the connections necessary to use the Water Rainbow as a fill spout, follow this procedure:
• Turn OFF circuit breakers at the main electrical panel and drain the spa completely.
• Unscrew the spout from the 3/4" pipe.
• Cut the 3/4" piping as shown in the illustration below.
• Cap the piping by cementing a 3/4" PVC cap where cut has been made.
• Connect permanent plumbing line to the spout.
SAVE FOR LATER
REINSTALLATION
(IF DESIRED)
PRODUCT SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
USE INSTALLATION INSTRUCTIONS SUPPLIED WITH PRODUCT.
Jacuzzi Whirlpool Bath has obtained applicable code (standards) listings generally available on a national basis for products of this type.
It is the responsibility of the installer/owner to determine specific local code compliance prior to installation of this product. Jacuzzi Whirlpool
Bath makes no representation or warranty regarding, and will not be responsible for any code compliance.
Printed on Recycled Paper
®
as Fill Spout
WATER RAINBOW SPOUT
SPA SHELL
1-1/2" to 2"
CUT PIPE HERE
Jacuzzi Whirlpool Bath National Headquarters
P.O. Drawer J, Walnut Creek, CA 94596 (925) 938-7070
Service Support: Call (800) 288-4002
©1999 Jacuzzi Whirlpool Bath R906000 3/00
INSTALL AND CEMENT
3/4" PVC CAP HERE
TEE LOCATED ON
DISCHARGE
PIPING
SUGGESTED MODIFICATION
(REFER TO LOCAL CODES FOR
REQUIREMENTS)
23
Printed in the U.S.A.