Testing In Invert Mode; Testing In Shore Power Mode - Xantrex PRO XM 1000 Owner's Manual

Installation

Testing in Invert Mode

To test the XM Series Inverter in invert mode:
1. For hardwired installations, ensure shore power is not present.
2. Press the on/off button to turn the inverter on.
3. Plug an appliance within the power rating of the inverter into the XM
4. Turn the appliance on to verify that it operates.
If the appliance operates, your installation is successful. If your installation
has AC input and output hardwired to the XM Series Inverter, proceed to

"Testing in Shore Power Mode".

If the status LED on the display panel glows red, see the Troubleshooting
chapter.
Testing in Shore Power Mode
To test the XM Series Inverter in shore power mode:
u With the appliance from the previous test still connected and operating,
Note:
Inverter will automatically supply the appliances with inverter power if the shore
power source fails or becomes disconnected.
If the on/off button on the XM Series Inverter is on and shore power voltage is too
low (less than 90 volts AC), the unit will transfer to inverter power to continue
running your appliances.
Note:
XM Series Inverter.
3–22
The status LED on the display panel glows yellow and the LED display
illuminates.
Series Inverter GFCI or an AC outlet hardwired to the XM Series
Inverter.
connect the shore power source.
The XM Series Inverter transfers the appliances to shore power. The
status LED on the display panel glows green.
If the appliance operates, your installation is successful.
If the on/off button on the XM Series Inverter is on, the XM Series
Whether or not the on/off button is on, shore power will pass through the
975-0263-01-01