Wall Switch Installation For Fan (Optional); Junction Box Installation - Heatilator CB4236IR Owner's Manual

D. Junction Box Installation
If the box is being wired from the OUTSIDE of the appli-
ance:
• Remove the cover plate located on the outer shell - right
side (see Figure 10.2).
• Install the supplied Romex™ connector in the cover
plate.
• Feed the necessary length of wire through the
connector.
• Make all necessary wire connections and reattach the
cover plate to the outer shell.
If the box is being wired from the INSIDE of the appli-
ance:
• Remove the screw attaching the junction box/receptacle
to the outer shell, rotate the junction box inward to
disengage it from the outer shell (see Figure 10.2).
• Pull the electrical wires from outside the appliance
through this opening into the valve compartment.
• Feed the necessary length of wire through the
connector.
• Make all necessary wire connections to the junction
box/receptacle and reassemble the junction box/
receptacle to the outer shell.
E. Wall Switch Installation for Fan (Op-
tional)
If the box is being wired to a wall mounted switch
for use with a fan (See Figure 10.3):
• The power supply for the appliance must be
brought into a switch box.
• The power can then be supplied from the switch
box to the appliance using a minimum of 14-3
with ground wire.
• At the switch box connect the black (hot) wire
and red (switch leg) wire to the wall switch as
shown.
• At the appliance connect the black (hot), white
(neutral) and green (ground) wires to the junction
box as shown.
• Add a 1/4 in. insulated female connector to
the red (switch leg) wire, route it through the
knockout in the face of the junction box, and
connect to the top fan switch connector (1/4 in.
male) as shown.
Figure 10.3 Fan Control Switch Wiring
Heatilator • Caliber BV Series • 4040-262 Rev F • 05/07
Figure 10.2 Junction Box Detail
Minimum 14-3 AWG
with Ground
Red
Black
White
Junction Box
Red
Romex
Connector
14/2WG
Cover Plate
outside firebox
Copper
ground attached
GRN wire
to GRN screw with
inside box
GRN wire
Note: Do NOT wire 110
VAC to wall switch.
Black
White
Green Green
Switch Box
Knockout
Switch
Power
Supply
Wires
23