Gas And Electrical Connections; Securing And Leveling Appliance - Heatilator CB4236IR Owner's Manual

NO
NO
Outlet blocked by
snow, leaves, etc.
YES
Clear area
outside
house or in
ventilated
crawl space
Use only duct materials specified
by manufacturer (preferably with
short run or mainly straight duct,
except small dip for cold air trap
which will help prevent flow of cold air).
Figure 7.3 Outside Combustion Air Placement
B. Gas and Electrical Connections
If applicable, ensure that gas and electrical connections are
installed at this time. Refer to Sections 9 and 10.
C. Securing and Leveling Appliance
WARNING
Fire Risk!
• Prevent contact with sagging, loose
insulation.
• Do NOT install against combustible
materials such as exposed insulation,
plastic and insulation backer.
The diagram shows how to properly position, level, and se-
cure the appliance (see Figure 7.3). Nailing tabs are pro-
vided to secure the appliance to the framing members.
• Place the appliance into position.
• Level the appliance from side to side and front to back.
• Shim the appliance as necessary. It is acceptable to use
wood shims.
• Bend out nailing tabs on each side.
• Keep nailing tabs fl ush with the framing.
• Secure the appliance to the framing by using nails or
screws through the nailing tabs.
CAUTION
Do NOT notch into the framing around the appliance
spacers.
Garage or
NO
combustible
liquids storage Attic space
NO
higher than 3 ft
termination cap
Factory-built
fireplace
Heatilator • Caliber BV Series • 4040-262 Rev F • 05/07
Outlet placed
below the
Nailing Tabs
(both sides)
Figure 7.3 Proper Positioning, Leveling and Securing of an
Appliance
17