Table of Contents
Advertisement
PILOT
THERMOCOUPLE
VALVE
Figure 35. Standing Pilot Ignition Wiring Diagram
Step 8. Wiring the Appliance
NOTE: Electrical wiring must be installed by a licensed
electrician.
CAUTION: DISCONNECT REMOTE CONTROLS IF AB-
SENT FOR EXTENDED TIME PERIODS. THIS WILL PRE-
VENT ACCIDENTAL APPLIANCE OPERATION.
For Standing Pilot Ignition Wiring
Appliance Requirements
• This appliance DOES NOT require 110-120 VAC to operate.
WARNING: DO NOT CONNECT 110-120 VAC TO
!
THE GAS CONTROL VALVE OR WALL SWITCH
OR THE APPLIANCE WILL MALFUNCTION
AND THE VALVE WILL BE DESTROYED.
BLK
BLK
BLK
TEMPERATURE
SENSOR SWITCH
Figure 36. Fan Wiring Diagram
40
PIEZO
RED
VARIABLE SPEED CONTROL
JUNCTION BOX
BLK
BLK
BLK
BLK
Heat & Glo • SL-550 / 750 / 950TR-D • 2044-985 Rev. J • 6/06
THERMOSTAT
WIRE ASSEMBLY
Wall Switch
Position the wall switch in the desired position on the wall.
An assembly of 18 ft of 20 AWG is provided with the fire-
place to connect the wall switch to the appliance. Instead of
the supplied assembly, wire with a length of 25 ft or less and
a gauge of 20 AWG through 14 AWG is acceptable. The
wire needs a jacket with a temperature rating of 140
or higher. At the appliance connect the wire to the ON/OFF
switch pigtails.
CAUTION: LABEL ALL WIRES PRIOR TO DISCONNEC-
TION WHEN SERVICING CONTROLS. WIRING ER-
RORS CAN CAUSE IMPROPER AND DANGEROUS
OPERATION. VERIFY PROPER OPERATION AFTER
SERVICING.
BLK
BLK
WHT
WHT
GROUND
GRN
WHT
110-120 VAC
NOTE: A wall switch or re-
mote must be used on
this appliance.
Optional Accessories
Optional fan and remote con-
trol kits require that 110-120
VAC be wired to the factory
installed junction box before
the appliance is permanently
installed.
NOTE: IF ANY OF THE ORIGINAL WIRE
AS SUPPLIED WITH THE APPLIANCE
MUST BE REPLACED, IT MUST BE
O
REPLACED WITH TYPE 105 C RATED WIRE.
BLOWER RECEPTACLE
o
F (60
o
C)
BLOWER
Hide quick links:
Advertisement
Table of Contents
