Step 9 Finishing - Heat & Glo SL-950TR-D Owner's Manual

Step 9. Finishing
Figure 38 shows the minimum vertical and corresponding
maximum horizontal dimensions of appliance mantels or
other combustible projections above the top front edge of
the appliance. See Figures 4 and 5 for other appliance
clearances.
Only non-combustible materials may be used to cover the
black appliance front.
WARNING: WHEN FINISHING THE APPLIANCE,
!
NEVER OBSTRUCT OR MODIFY THE AIR INLET/
OUTLET GRILLES IN ANY MANNER.
6"
5"
4"
3"
2"
1"
3"
2"
1"
TOP FRONT EDGE
OF FIREPLACE
Figure 38.
Minimum Vertical and Maximum Horizontal
Dimensions of Combustibles above Appliance
42
CEILING
12"
11"
10"
9"
31"
8"
7"
12"
11"
10"
9"
8"
7"
6"
5"
4"
Heat & Glo • SL-550 / 750 / 950TR-D • 2044-985 Rev. J • 6/06
CAUTION: IF JOINTS BETWEEN THE FINISHED WALLS
AND THE APPLIANCE SURROUND (TOP AND SIDES)
ARE SEALED, A 300° F. MINIMUM SEALANT MATE-
RIAL MUST BE USED. THESE JOINTS ARE NOT RE-
QUIRED TO BE SEALED. ONLY NON-COMBUSTIBLE
MATERIAL (USING 300° F. MINIMUM ADHESIVE, IF
NEEDED) CAN BE APPLIED AS FACING TO THE APPLI-
ANCE SURROUND. SEE THE DIAGRAM BELOW.
TOP SEAL
JOINT
SIDE SEAL
JOINT
0"
Figure 39. Sealant Material
Hearth Extensions
A hearth extension may be desirable for aesthetic reasons.
However, ANSI or CAN/CGA testing standards do not require
hearth extensions for gas appliance appliances.
FINISH MATERIAL
MAY BE COMBUSTIBLE
- TOP AND SIDES
OF UNIT
1/4"