The chassis should be connected to an earth ground using the ground stud
located between the AC and DC power sources on the rear panel.
PWR FAIL Battery backup connection. If AC fails, a trap is sent to
61200290L1-1
Table 2-1. DC Connector Symbol Definitions
Symbol
alert user.
-
Negative side of DC power source (usually -48V)
RET
Positive side of DC power source (usually ground)
Frame Ground
MX2800 User Manual
Chapter 2. Installation and Operation
PWR
PWR
FAIL
FAIL
Figure 2-1. DC Power Connector
Definition
2-3