Table of Contents
Advertisement
C
O
M
M
E
R
C
CHECKING THE ALIGNMENT OF THE RUNNING BELT
The belt is aligned at the factory before shipment. However, during shipment or by
using the treadmill on an uneven surface, the belt might move off center. Proper
belt alignment is important because it allows the belt to remain centered and
assures smooth operation.
Follow these steps to check the alignment:
CAUTION: Do not walk on the running belt during this procedure.
1. The treadmill has adjustable rear feet. Check to make sure that the running
surface is level (refer to steps 15 and 16 on the previous pages). If the
treadmill is placed on a slightly uneven surface, adjusting the rear feet can
help, but will not compensate for extremely uneven surfaces.
2. Locate the I/O switch at the front of the treadmill and turn the unit ON.
3. Stand beside the treadmill and press QUICKSTART. The running belt starts
automatically after the message, " Belt Starting 3, 2, 1,... " appears.
CAUTION: If you hear any chafing or the running belt appears to be
getting damaged, stop the running belt immediately by pressing the
STOP key. Contact Customer Support.
4. Continue standing next to the treadmill and hold down the SPEED ▲ key
until the display shows a speed of 3 miles per hour (5 kph).
5. Walk around to the rear of the unit and observe the belt for a few minutes as
it moves.
If the running belt,...
tracks centered on the running surface
(evenly distributed between the side rails)
runs or drifts off center
Important: If you notice that the belt needs alignment, make the adjustments at
once. Failure to do so might cause the belt to tear or fray, which is not covered by
the Precor, limited warranty.
6. To stop the running belt, press the red STOP button.
If the belt is functioning correctly, the C932i treadmill is ready to use.
page 20
I
A
L
P
R
O
D
U
C
T
S
D
I
V
Then,...
the belt is functioning correctly
and no adjustment is necessary.
you need to adjust the belt; see
Aligning the Running Belt, page 48.
I
S
I
O
N
Advertisement
Table of Contents
