Junction Box Wiring Installation Instructions - Empire Comfort Systems DVCD32FP30N-1 Owner's Manual

JUNCTION BOX WIRING INSTALLATION INSTRUCTIONS

CAUTION: ALL WIRING SHOULD BE DONE BY A qUALIFIED ELECTRICIAN AND SHALL BE IN COMpLIANCE WITH
ALL LoCAL, CITY AnD STATE BUILDInG CoDES. BEFoRE MAKInG THE ELECTRICAL ConnECTIon, MAKE SURE
THAT MAIN pOWER SUppLY IS DISCONNECTED. THE AppLIANCE, WHEN INSTALLED, MUST BE ELECTRICALLY
GROUNDED IN ACCORDANCE WITH LOCAL CODES OR, IN THE ABSENCE OF LOCAL CODES, WITH THE NATIONAL
ELECTRICAL CODE ANSI/NFpA 70 (LATEST EDITION).
A factory installed junction box is located on the lower right
side of the fireplace. Wiring must be fed to the junction
box and attached to the receptacle that is provided.
Leave approximately 6" of wire in the junction box for
connection.
Attach black wire to one side of the receptacle and white
wire to opposite side of receptacle. The ground wire should
be attached to the green (ground) screw.
Install the receptacle into the junction box. Attach cover
plate.
1. To wire Junction Box Receptacle, remove the tab on the
side of the receptacle (hot side) to split receptacle. This
will be required to separate blower and valve circuits.
2. Power for switched and live sides of Duplex Receptacle
must come from the same power source. (One circuit
breaker on main panel must switch all power off.)
28365-2-0811
STANDARD MILLIVOLT VALVE MODELS
120V DIRECT IGNITION VALVE MODELS
3. From the wall box to the fireplace a 3-wire conductor
with ground is recommended, however (2) two-wire
conductors with grounds may be used in place of a
3-wire conductor with a ground if the black wires from
the thermostat and blower switch are identified.
4. Two wall switches, or a wall switch and thermostat
may be used to activate the two receptacle plugs
independently.
Page 55