Operating Instructions; How To Use Your Machine As A Dry Cleaner - Electrolux WET & DRY EXTRACTION VACUUM CLEANERS Owner's Handbook Manual

OPERATING
INSTRUCTIONS
WARNING. Always
disconnect your vacuum
cleaner from the mains
supply before maintaining
and or assembling it.
1. Before you can start using your
vacuum cleaner, you must attach
the castors (6). The castors
(6) can be found inside the
vacuum cleaner. To open the
vacuum cleaner lift the latches.
See fig. 4.
2. Remove the castors (6) and fit
them to the bucket (5) by driving
each castor (6) fully into the
holes at the bottom of the bucket
(5). See fig. 5.
HOW TO USE YOUR MACHINE
AS A DRY CLEANER
1. Assemble your vacuum cleaner
using the components shown in
fig. 1.
2. For your convenience the
vacuum cleaner is supplied with
the cloth filter (4) fitted. This is
to be used for dry vacuuming.
To fit the cloth filter (4) clip it
over the top rim of the bucket
(5). Ensure it is fitted all the way
round. See fig. 6.
4. Fit the solution filter (8) to the
pin on the underside of the hood
assembly (1). See fig. 7.
Fig. 4
5 Fit the hood assembly (1) onto
the bucket (5) and secure using
the latches. See fig. 8.
Fig. 5
6. When the hood assembly (1) is
properly fitted the valve (3)
should line up perfectly with the
6
Fig. 6
Fig. 7
Fig. 8