Electrolux WET & DRY EXTRACTION VACUUM CLEANERS Owner's Handbook Manual page 8

3. Fit the solution filter (8) to the
pin on the underside of the hood
assembly (1). See fig.7.
4. Fit the hood assembly (1) to the
bucket (5) and secure using the
latches. See fig. 8.
5. When the hood assembly (1)
is properly fitted the valve (3)
should line up perfectly with the
hose intake (9). See fig. 9.
6. Connect the hose (10) to the
bucket (5) by fitting the threaded
end of the hose (10) into the
hose intake (9) and turn in a
clockwise direction to secure.
See fig. 10.
7. Fit the extension tubes (13) and
other accessories (whichever is
required) to the hose (10). See
fig. 2
8. If you intend using the carpet
shampoo nozzle (21), you will
have to make use of the
shampoo nozzle adaptor (19).
As the flow control unit (18) is
connected to the shampoo
nozzle adaptor (19), it will have
to be fitted to the curved handle
(11). See fig. 14.
9. The shampoo nozzle adaptor
(19) must be attached to the
extension tube (13) see fig. 3
NOTE: The wet tool (20) is fitted
with a rubber squeegee to vacuum
spills while sweeping hard floors.
Remove the rubber squeegee when
the wet tool (20) is used on carpets
or fabrics.
10. The tubing that is attached to the
shampoo nozzle adaptor (19)
and flow control unit (18), can
be secured onto the hose (10)
and extension tubes (13) with
the aid of the hose clamps (17).
When fitting the hose clamps
(17) to the extension tubes (13)
make sure that the pimple on the
hose clamp (17) is seated on
the dimple on the extension
tube (13).
11. Any excess tubing can be
wrapped around the hose (10).
Once the tubing has been
secured to the hose (10), the
metal fitting at the end of the
clear tubing can be clipped into
the valve (3) on the hood
assembly (1). See fig. 15.
12. Once all the required accessories
have been fitted together, plug
the mains lead into the wall
socket and press the on/off
switch (2) to start vacuuming.
Fig. 14
See fig. 11.
13. For the best results, keep the
suction regulator (12) closed
8
Fig. 15