Table of Contents
Advertisement
NOTE: The surface being
shampooed gets dried during the
release of the solution. Further drying
can take place by moving the nozzle
over the surface again without
pressing the trigger of the flow
control unit (18).
5. When you have completed using
your vacuum cleaner, it should
be disassembled in the reverse
order in which you have
assembled it.
6. To detach the metal fitting from
the valve (3), depress the valve
button and pull the metal fitting
out. See fig. 27.
IMPORTANT: Never spray the
shampoo solution in the direction
of an electrical socket or any other
electrical equipment.
GENERAL
TROUBLE SHOOTING
No shampoo release:
If pressing the trigger does not
release the shampoo solution, check
the following:
•
The pump switch (7) is on.
See fig. 28.
•
The solution filter (8) is
inserted correctly into the
solution tank (22). See fig. 29.
No power:
Fig. 27
If your vacuum cleaner does not
operate, check the following:
•
The plug connection.
•
The electrical wall socket is
switched on.
Loss of suction:
If your vacuum cleaner loses suction
power, check the following:
•
Hose (10) and other accessories
in use are not blocked.
•
The filters (4 & 16) are clean.
•
The bucket (5) is not overfull
and that the protective filter is not
blocked.
12
Fig. 28
Fig. 29
Hide quick links:
Advertisement
Table of Contents
