Audio Sources And Priorities; Attaching And Removing The Headset From The Helmet Clamp; Using The Headset - Cardo Systems SCALA RIDER SOLO User Manual

Lead the speaker cord [B]
alongside the rim of the padding
to the right side and then back to
the left side, near speaker [A].
Then place the speaker [B]
underneath the padding.
ATTACHING AND REMOVING THE HEADSET
FROM THE HELMET CLAMP
ATTACHING:
Slide the headset downwards along the
sliding panel until a clicking sound
indicates that the headset is locked in
place.
REMOVING:
Your headset can be removed for
charging and storage by pressing your
finger gently against the tab and
sliding the headset up with the other
hand.
We recommend that you remove the
headset from the helmet when not in
use.
Cable
Speaker B
Speaker B
Speaker A
Press here
to remove

AUDIO SOURCES AND PRIORITIES

The different Audio Sources that are connected to the scala rider
Solo are prioritized as follows:
Highest: 1. Mobile phone audio (Incoming/outgoing calls) / GPS
device (GPS audio and navigation instructions)
Lowest 2. MP3 Connectivity
A high priority Audio Source will always interrupt any lower priority
Audio Source. i.e. Mobile phone call overrides MP3 Player

USING THE HEADSET

GENERAL USAGE
GENERAL FUNCTIONS
DESIRED RESULT: REQUIRED ACTION:
Turn on the
Press the CTRL Button steadily for at least three
headset seconds. Led indication: three blue flashes.
Audio feedback: Ascending tone (low-high).
Turn off the Press the CTRL Button steadily for at least three
headset
seconds. Led indication: three red flashes.
Audio feedback: Descending tone (high-low).
Increase the
Tap the Volume Up Button
volume
Decrease the
Tap the Volume Down Button
volume
AGC (Automatic Gain Control): In addition to manual Volume Control,
the scala rider Solo will automatically increase and reduce its vol-
ume according to ambient noise and driving speed.
scala rider Solo 7
® ™