Audio Tones; Troubleshooting; Phone-Related Problems (Driver Unit With Bluetooth Phone) - Cardo Systems Scala-rider TeamSet Quick Manual

AUDIO TONES

With the exception of the actions below, all other actions are followed
by a single tone to confirm that the headset has accepted the command.
Action
Enable/Disable Always On
intercom
Intercom on other side is
not enabled or off and you
start speaking

TROUBLESHOOTING

Problem

Phone-Related Problems (Driver Unit with Bluetooth Phone)

Unsuccessful Bluetooth Pairing 1. If listed, delete scala-rider from your paired
I cannot hear stereo sound
Can't answer calls or perform
voice dialing by pressing the
Control Button
Tone
One tone = Always On intercom
Two tones = Voice Controlled (VOX) intercom
2 beeps to alert you that the other side is not
available
Action
device list of your phone.
2. Turn off the phone and headset.
3. Remove the battery from the phone, then place
the battery back in the phone.
4. Repeat the pairing process as described above.
The two speakers provide only dual mono signals.
1. Make sure that the scala-rider headset is turned
ON and in standby mode with the blue Status
Light slowly flashing.
2. Verify that the Bluetooth function on your phone
is set to ON.
12