Convenient Functions
Personal Memory Plus Function
This function sets the settings (input mode, surround
mode, etc.) last selected for the individual input sources.
When you switch to an input source, the settings are
automatically set to the ones that were set the last time
that input source was used.
The surround parameters, tone adjustment and the volumes of the
different speakers are stored for the individual surround modes.
Last Function Memory
This stores the settings as they were directly before the
standby mode was set.
When the power is turned back on, the settings are
restored to as they were directly before the standby mode
was set.
Backup Memory
The various settings are backed up for about 1 week,
even if the power is turned off or the power cord is
disconnected.
Auto Power On
When the power is in the standby mode, the power turns
on simply by pressing <5> or <1>.
Resetting the Microprocessor
Perform this procedure if the display is abnormal or if
operations cannot be performed.
When the microprocessor is reset, all the settings are
reset to their default values.
1
<ON/STANDBY>
Setthestandbymodeusing
b Set to the standby mode and wait 5 seconds.
2
<ON/STANDBY>
Press
whilesimultaneouslypressing
<FUNCTION>
<8>
and
.
3
Oncethedisplaystartsflashingatintervalsofabout1
second,releasethethreebuttons.
If in step 3 the display does not flash at intervals of about 1 second,
start over from step 1.
.
ENGLISH