Optional Blower Installation Instructions - Empire Comfort Systems VFD10CC series Owner's Manual

OPTIONAL BLOWER INSTALLATION INSTRUCTIONS

Installing Optional CIB4 Blower
the four (4) hex-head screws that were loosened in Step 1.
10 x 1/2" screws on left side of the appliance. NOTICE: Some
are missing from part removed from unit, discard wire channel
removed from unit and continue installation with appropriate
5. Route fan control wires through rectangular notch on wire
channel - left.
8. Attach 1/4" push-on terminal from white wire on the fan control
9. Insert AUTO/OFF/ON switch into rectangular notch on wire
channel - left.
29560-0-0312
BLOWER ASSEMBLY
10. Install rheostat through hole in wire channel and align small
11. Use an 11/16" wrench to tighten rheostat nut on stationary portion
into slot.
15. Route wires from fan control and ON/OFF/REMOTE switch
within wire channel.
16. Attach wire channel to channel divider with two (2) 10 x 1/2"
screws from Step 4.
Fan Control
AUTO/OFF/ON SWITCH
FAN CONTROL
Figure 28
NOTICE: Nut is self-tapping and
Page 37