Introduction - Empire Comfort Systems VFD10CC series Owner's Manual

Always consult your local Building Department regarding regulations,
codes or ordinances which apply to the installation of an unvented
room heater.
state or local codes.
the manufacturer.
This appliance is only for use with the type of gas indicated on the
rating plate.
Instructions to Installer
1. Installer must leave instruction manual with owner after
installation.
card supplied with unvented room heater.
3. Installer should show owner how to start and operate unvented
room heater.
these instructions.
Notice:
shipping damage.
odor as the ceramic log is cured.
unless all components including logs, burners, and controls
Refer to Log Placement on page 10 for correct log and twig
positioning.
indicated in the Parts Sections on pages 31 through 35.
This appliance is equipped for (natural or propane) gas. Field
conversion is not permitted.
This unit is not for use with solid fuels.
Important
Notice:
the room in which the unit is installed.
Installation in Residential Garages
29560-0-0312

INTRODUCTION

WARNING
WARNING
Preparation
when installed in accordance with this Installation Manual. Report
log placement. Do not install unit with damaged, incomplete, or
and follow these instructions carefully during installation to insure
Inc.
State of Massachusetts:
Massachusetts.
room heaters shall provide to each purchaser a copy of 527 CMR
30 upon sale of the unit. In the State of Massachusetts, unvented
of local codes, with the National Fuel Gas Code, ANSI Z223.1/
NFPA 54.*
*Available from the American National Standards Institute, Inc., 11
West 42nd St., New York, N.Y. 10036.
ANY CHANGE TO THIS FIREPLACE OR ITS CONTROLS CAN
BE DANGEROUS.
poisoning.
High Altitudes
WARNING
Page 5