Ip Operating Instructions - Empire Comfort Systems VFD10CC series Owner's Manual

Attention: For shipping purposes, the Electronic Control
the appliance at the time of installation. To secure, remove
5.25 VDC ELECTRONIC CONTROL VALVE
the pilot from a standing pilot mode to an intermittent pilot mode.
IPI Mode - In the Intermittent Pilot mode, when the unit is
CPI Mode - In the Continuous Pilot mode, the pilot re-
OFF.
Note: A small toggle switch is located on the receiver plate (left
side of unit) that is used to switch from IPI (upward position) to the
CPI (downward position). See Figure 20.
When the unit is turned to ON, the electrical current will energize
DFC
ELECTRONIC
CONTROL
MODULE
PILOT
SENSOR
REMOTE
CONTROL
RECEIVER
AA (4)
BATTERY
BACKUP
Page 22

IP OPERATING INSTRUCTIONS

9 PIN CONNECTOR
GROUND
SPARK ROD
PILOT SELECTOR SWITCH
IPI - INTERMITANT PILOT (UP)
CPI - CONTINUOUS PILOT (DOWN)
IPI
CPI
OUTLET
PRESSURE
TAP
1. Follow the SAFETY and LIGHTING INSTRUCTIONS for In-
found in the control compartment located in the lower cavity
of the appliance.
2. During the operating season (or in power outage periods), it is
recommended that the pilot remain in the CPI (standing pilot
3. The gas valve has inlet and outlet pressure taps as shown in
Note:
height.
OPTIONAL REMOTE CONTROLS
the ON/OFF switch wires from the white and green wire connec-
tors and connect the wires from the remote receiver to the green
and white wire connectors. See Figure 20.
Follow the instructions included with the remote control for pro-
gramming and other operational information.
IGNITOR
INLET
PRESSURE
TAP
Figure 20
SENSOR
PILOT
ASSEMBLY
GAS VALVE
29560-0-0312