Product Overview; Htx 2030 With Base Coat Pump (257369) - Graco HTX 313888B Operation Manual

Graco inc. paint sprayer operation manual
Table of Contents

Advertisement

Product Overview

HTX 2030 with Base Coat Pump
(257369)
ti13632a
The HTX 2030 Sprayer comes equipped with a Base
Coat Pump 24B321. Only water-based materials are to
be used with this configuration, such as:
Smooth to heavily aggregated textures with silica
sand, perlite, vermiculite and polystyrene
Smooth, medium, coarse and extra coarse textures
Most materials with aggregates up to 2.5 mm (.100
in.) in longest dimension
When Base Coat Pump is Installed
Pump will only run when on/off switch is in ON position
AND:
Pump control is rotated clockwise away from OFF
position, and either of the following switches are
also switched ON:
Prime Switch on pressure control box AND/OR
Applicator Switch near end of material hose
The pressure control will limit the sprayer to 1,000 psi
(69 bar), stopping the pump whenever pressure limit is
reached.
Flow rate is dependent on engine speed and the setting
of the pump control knob.
313888B
1. Flow 3 (fully clockwise) - allows the pump to run
continuously with minimal pulsation:
2. Flow 2 (near middle of the rotation) reduces flow
slightly by briefly interrupting pump:
3. Flow 1 (near counterclockwise end of pump control)
reduces flow more by interrupting pump longer:
4. OFF (fully counterclockwise) - stops pump com-
pletely:
NOTE: Adjusting engine speed is an effective way to
control flow rate of sprayer. Different spray tip nozzle
sizes can also be tried.
Product Overview
ti13756a
ti13757a
ti13758a
ti13755a
5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Htx 2030257369

Table of Contents