Table of Contents
Advertisement
8. While a second person holds the Console (16) near
the Upright (13), connect the console wire to the
Extension Wire (23). Then, insert the wires down-
ward into the Upright.
Attach the Console (16) to the Upright (13) with four
M6 x 15mm Button Screws (46). Be careful to
avoid pinching the wires.
9. Identify the Left Pedal (24), which is marked with a
"Left" sticker. Using an adjustable wrench, firmly
tighten the Left Pedal counterclockwise into the left
arm of the Crank (21). Tighten the Right Pedal (not
shown) clockwise into the right arm of the Crank.
IMPORTANT: Tighten both Pedals as firmly as
possible. After using the exercise cycle for one
week, retighten the Pedals. For best performance,
keep the Pedals tightened.
Adjust the strap on the Left Pedal (24) to the
desired position, and press the end of the strap
onto the tab on the side of the Left Pedal. Adjust the
strap on the Right Pedal Strap (not shown) in the
same way.
10.Make sure that all parts are properly tightened before you use the exercise cycle. Note: After assembly is
completed, some extra parts may be left over. Place a mat beneath the exercise cycle to protect the floor.
8
23
46
9
Strap
Tab
24
8
16
Console
Wire
13
Be careful to
avoid pinching
the wires
21
Advertisement
Table of Contents
