Table of Contents
Advertisement
6. While another person holds the Upright (13) near
the Frame (1) as shown, connect the Extension
Wire (23) to the Reed Switch Wire (39). Next, con-
nect the Resistance Cable (19) to the Lower
Cable (29) in the following way:
• See drawing A. Pull up on the metal bracket on
the Lower Cable (29), and insert the tip of the
Resistance Cable (19) into the wire clip inside of
the metal bracket as shown.
• See drawing B. Firmly pull the Resistance
Cable (19) upward and slide it into the top of the
metal bracket as shown.
• See drawing C. Using pliers, squeeze the prongs
on the upper end of the metal bracket together.
Push the Wires (23, 39) and the Cables (19, 29)
downward into the Frame (1).
Next, insert the Upright (13) into the Frame (1). Be
careful to avoid pinching the wires and cables.
Attach the Upright with three M8 x 15mm Button
Screws (34) and three M8 Split Washers (42).
7. The Console (16) requires four AA batteries (not
included); alkaline batteries are recommended.
IMPORTANT: If the exercise cycle has been
exposed to cold temperatures, allow it to warm
to room temperature before inserting batteries
into the Console. If you do not do this, the con-
sole displays or other electronic components
may become damaged. Press the tab on the bat-
tery cover and remove it. Insert four batteries into
the Console as shown. Make sure that the batter-
ies are oriented as shown by the diagram on the
battery cover. Then, reattach the battery cover.
6
13
19
39
29
42
34
1
A
Metal
Bracket
19
29
7
7
Be careful to
avoid pinching
the wires and
cables
23
42
34
C
B
Metal
19
Bracket
29
Battery
Cover
Batteries
16
Advertisement
Table of Contents
