Table of Contents
Advertisement
3. Attach the Left and Right Upright Covers (14, 15)
around the Frame (1) with three M4 x 25mm Round
Head Screws (41) as shown.
4. Attach the Seat (12) to the Seat Post (5) with four
M8 Split Washers (42) and four M8 Nylon
Locknuts (10). Note: The Split Washers and the
Nylon Locknuts may be pre-attached to the
underside of the Seat.
5. Turn the Seat Knob (9) counterclockwise and
remove it from the Frame (1). Next, insert the Seat
Post (5) into the Frame. Adjust the Seat Post to the
desired height and insert the Seat Knob (9) through
the indicated hole in the Frame into one of the
adjustment holes in the Seat Post. Then, turn the
Seat Knob clockwise until it is tight. Make sure the
Seat Knob is firmly engaged in one of the
adjustment holes in the Seat Post.
3
1
41
14
4
12
42
10
5
5
1
6
15
41
42
10
Adjustment
Holes
5
Hole
9
Advertisement
Table of Contents
