Cc Management Settings - ATEN Altusen KN1108v User Manual

On the LDAP / LDAPS server, Users can be authenticated with any of the
following methods:
With MS Active Directory schema.
Note: If this method is used, the LDAP schema for MS Active Directory
must be extended. See LDAP Server Configuration, page 211, for
details.
Without schema – Only the Usernames used on the KN1108v / KN1116v
switch are matched to the names on the LDAP / LDAPS server. User
privileges are the same as the ones configured on the switch.
Without schema – Only Groups in AD are matched. User privileges are the
ones configured for the groups he belongs to on the switch.
Without schema – Usernames and Groups in AD are matched. User
privileges are the ones configured for the User and the Groups he belongs
to on the switch.

CC Management Settings

To allow authorization for the KN1108v / KN1116v switch through a CC
(Control Center) server, check Enable and fill in the CC Server's IP address
and Service port in the appropriate fields. You can use the IPv4 address, the
IPv6 address or the domain name in the CC Server IP field.
Note: If this function is enabled, PON devices and Blade Servers do not
appear in the Sidebar, even if they are configured on the switch. This is
because they are managed via the CC server.
Chapter 8. Device Management
154