Toyota Sienna 2000 Operating Manual page 54

2. Remove the head restraint. Unlock
the seat legs by pulling up the left
side handle under the seat,
swing the whole seat up and for-
ward.
After returning the seat to its origi-
nal position, be certain to replace
the head restraint.
Folding the third seats will enlarge the
luggage compartment. See "Luggage
stowage precautions" in Section 2 for pre-
cautions to observe for loading luggage.
54
00 SIENNA(U)
CAUTION
D
When folding up the seat or return-
ing it to its original position, be
careful not to get your hands or
feet pinched in the seat.
D
Be certain to replace head restraint.
D
Make sure the seat
locked by pushing forward and rear-
ward on the top of the seatback or
by trying to pull up the edge of the
bottom cushion. Failure to do so
will prevent seat belt from operat-
ing properly.
and
—Removing third seats
is securely
BEFORE REMOVING THIRD SEAT
Stow the third center seat
shown in the illustration.
This prevents the belt from falling out
when you remove the third seat.
z The third center seat belt must be
stowed before you remove the third
seat.
belt as
NOTICE