Toyota Sienna 2000 Operating Manual page 33

Table of Contents

Advertisement

SETTING THE SYSTEM
1. Turn the ignition key to the "LOCK"
position and remove it.
The indicator light will start flashing every
1 second when the key is removed from
the
ignition
switch.
(See
immobiliser system" for details.)
2. Have all passengers get out of the
vehicle.
3. Close the front, sliding and back doors
and hood. Then lock all the doors with
the key or wireless
remote control
transmitter.
The indicator light will come on when the
front, sliding and back doors and hood are
closed and locked.
As the doors are locked, the system will
give you a preparation time of 30 seconds
before the setting, during which the front,
sliding or back doors and hood may be
opened.
Be careful not to unlock any door with the
key or wireless remote control transmitter
during setting. This will cancel the system.
4. After making sure the indicator light
starts flashing, you may leave the ve-
hicle.
The system will automatically be set after
the preparation time passes. The indicator
light will flash to show the system is set.
If any of the front, sliding or back doors
or hood is open at that time, the setting
is interrupted until it is closed and locked.
Never leave anyone in the vehicle when
you set the system, because unlocking
"Engine
from the inside will activate the system.
00 SIENNA(U)
WHEN THE SYSTEM IS SET
Activating the system
The system will give the alarm under the
following conditions:
D
If any of the front, sliding or back
doors is unlocked or if the hood is
forcibly opened without the key or wire-
less remote control transmitter
D
If the battery terminal is disconnected
and then reconnected
The indicator light will come on when the
system is activating.
If any of the doors is unlocked without the
key or wireless remote control transmitter
and the key is not in the ignition switch,
all the doors will be automatically locked
again.
After one minute, the alarm will automati-
cally stop and the indicator light will starts
flashing again.
Reactivating the alarm
Once set, the system cannot be cancelled
without the key or wireless remote control
transmitter. If the front, sliding and back
doors and hood are closed after the alarm
stops, the system automatically resets the
alarm.
33

Advertisement

Table of Contents
loading

Table of Contents