Toyota Sienna 2000 Operating Manual page 21

Table of Contents

Advertisement

OPEN POWER SLIDING DOOR WARN-
ING LIGHT AND BUZZER
This light on the instrument panel comes
on if the power sliding door is not com-
pletely closed with the ignition key in the
"ON" position. (See "Service reminder indi-
cators and warning buzzers" in Section
1- 5.)
If you forcibly close the power sliding door
by hand when the ignition key is in the
"ON" position, the open power sliding door
warning light may stay on. In this case,
try opening and closing the power sliding
door again by hand slowly, or use one of
the "PWR DOOR" switches or wireless
remote control transmitter.
00 SIENNA(U)
If you shift out of "P" when the power
sliding door is opened or in the process
of closing with the power sliding door sys-
tem on, a buzzer will sound and the open
power sliding door warning light will flash.
This is a warning that the sliding door is
not completely closed.
JAM PROTECTION FUNCTION
If anything with sufficient resistance ob-
structs the power sliding door while it is
closing or opening, the sliding door will
automatically reverse to the opposite di-
rection. However, if the power sliding door
is between
the fully- closed and half-
opened positions while it is opening, the
door will stop at that position.
Before operating the power sliding door,
make sure there is nobody near the slid-
ing door. Make sure the sliding door stops
at the fully- opened position, and then al-
low the passengers to get on and off the
vehicle.
21

Advertisement

Table of Contents
loading

Table of Contents