Graco 241705 Instructions-Parts List Manual page 13

28
18
25
Fig. 20
8. Position the trigger (25) on the gun body. Insert the
pivot pin (28) into the top hole (A) and secure with
the screw (29) on the other side. Place an e-clip
(27) on one end of the trigger pin (18). Slide the
pin through lower trigger holes and through the slot
(B) in the spring guide (16) (turn the spring guide
to align, as needed). Install the other e-clip (27).
See Fig. 20.
Turn in until screw
1
stops
Fig. 21
9. If it was removed, install the spring tension screw
(21) at the rear of the gun. Then, turn the screw in
until it stops. See Fig. 21.
Service
Test the Gun Before Regular Use
A
B,16
1. Lock the gun trigger safety. Connect a hose to the
gun. Start and prime the pump.
29
27
2. Release the gun trigger safety. Trigger the gun into
a waste container. Release the trigger to be sure
the gun immediately stops spraying and that there
are no leaks.
3. If the gun has a diffuser, check the diffuser using
the procedure on page 9.
04732
4. Install the tip guard (30) before regular use.
See Fig. 22.
21
1
Fig. 22
03980
30
03965
308491 13