Harman Stove Company XXV Installation & Operating Manual page 27

Pellet fines will accumulate in the feeder body over a period
of time; therefore, a yearly inspection and cleaning of this
must be performed.
To clean out fines:
1. Remove right rear cover panel.
2. Remove wing nut and feeder cover on the right side of
the feeder. See Fig. 43.
3. Use a vacuum cleaner to remove all fines.
4. Reinstall feed cover, wing nut, and right rear cover panel.
Feeder cover gasket
Feeder
cover
Wing
Nut
The glass in your Harman® stove is a special ceramic glass.
• Do not abuse the glass by striking or slamming the door.
• Never burn the appliance if the door glass is cracked or
broken.
• Replace only with 5mm ceramic glass supplied by your
Harman® dealer.
Soot and/or fly-ash may accumulate on the viewing glass,
and will ocassionally need to be cleaned. Clean the glass
with a soft cloth and mild glass cleaner. Do not clean the
glass when hot, and avoid the use of abrasive cleaners.
Glass replacement
Carefully remove all remaining glass and gasket materials
prior to replacing the glass.
Lay the door face down on a flat surface. Remove the glass
retainers and screws. Apply the gasket material to the face
of the new glass. Lay the glass into the door, making sure
that the glass is contained within the channels and raised
areas of the door itself. Lay the glass retainers into position
and install the screws. Tighten each screw evenly to avoid
making any stress points.
3-90-00684R22_04/13
Maintenance
Fig. 42
This enamel touch up paint is provided for fixing minor
enamel chips or blemishes that may occur after stove
installation. Unfortunately, because the enamel finish of
your stove is a baked on glass finish, this enamel touch up
paint may not be a perfect match to the color and gloss of
the original factory finish. To use this touch up paint: Ensure
the stove is cool and that the surface to be painted is clean.
Apply in several light coats and take care to only coat the
chipped area. Allow the paint to dry for 24 hours before
Fig. 43
touching or firing the stove.
Viewing glass
Glass
Screws &
Retainers
Two 5/16" socket hex screws on each side.
Enamel Touch-Up
Gasket
27
XXV Pellet Stove