Floor Protector
The Steel Floor Protector measures inches
wide by inches deep. This is the minimum size
for floor protection with this unit. It is made of 20
gauge steel.
harman Part #1-00-677036
This is used to
protect the floor
under horizontal
pipe run.
direct Vent wall Passthrough
The Harman Direct Vent Wall Passthrough makes
installing your Harman Pellet Stove with outside air
a lot easier. It is made to fit walls from 4 1/2" up to
10 1/8" thick with a square opening of 6" to 6 1/".
harman Part #1-00-677077
Outdoor Half
Indoor Half
Adjustable from 4 1/" to 10 5/8" wall thickness
Passthrough
hole for " PL
vent pipe
Options
XXV top Flue Option
The Top Flue option attaches to the exhaust on
the rear of the stove, and extends it to the top
with a six inch stub.
This gives the appearance of a wood stove and also
allows venting with existing single wall, connector.
A 1 inch piece of 4" pellet vent is included to act as
an insulator only. Note: The top flue adaptor is not
approved for use with pellet pipe. It is only tested
for use with chimney connector (6- inch pipe) into
an existing "class A" chimney.
harman Part #1-00-677120
Side View
6
XXV Pellet Stove