Table of Contents
Advertisement
SETTINGS
-----------------------------------------------------------------------------------------------------------------------------------------
Tuning terrestrial television
channels (DVB-T)
1 In the »Source Setup« menu, in the »Connec-
tion Type« line, select the option »Air« with
<
>
»
« or »
«.
2 Select the line »Scan Type« with »
»
«.
Λ
<
>
Use »
« or »
« to set the required scan
type:
– » DTV«, scan for digital television channels;
– » ATV«, scan for analogue television
c hannels;
– » ATV & DTV«, scan for analogue and
d igital television channels.
Caution:
The antenna power supply (5V ) may only
7
be switched on if the antenna is an active
i ndoor antenna with a signal amplifier and it
is not already supplied with a voltage via a
mains plug (or similar supply). Otherwise
you may cause a short circuit and irrepara-
bly damage your antenna.
3 Select the »Active Antenna Power« with »
or »
«.
Λ
Switch on the antenna power supply for the
<
antenna with »
« or »
4 Start the scan with »
– T he »Search Results« menu appears, and
the search for TV channels begins.
– D epending on the number of television
channels received, this can easily take a
few minutes.
– T he scan is complete as soon as the »PRO-
GRAM TABLE« appears.
Note:
You can abort the scan by pressing »
7
i
5 Press »
« to end the setting.
« or
V
«
V
>
« (»On«).
« (green).
i
«.
Tuning television channels from
the cable provider (DVB-C)
1 In the »Source Setup« menu, in the »Connec-
tion Type« line, select the option »Cable«
<
>
with »
« or »
«.
2 S elect the line »Scan Type« with »
»
«.
Λ
<
>
Use »
« or »
« to set the required scan
type:
– » DTV«, scan for digital television channels;
– » ATV«, scan for analogue television
c hannels;
– » ATV & DTV«, scan for analogue and
d igital television channels.
3 Select the »Scan Type« with »
lect the preferred option (»Quick« or »Full«)
<
>
with »
« or »
«.
– T he search function »Quick« sets up the
channels according to the information pro-
vided by your cable provider in the trans-
mission signal.
– I f the option »Full« is selected, the entire
frequency range will be scanned. The
search can take a long time with this op-
tion. This option is recommended if your
cable provider does not support the scan
type »Quick«.
Note:
You can accelerate the search. To do this,
7
you need information about the frequency
and network ID. You are usually able to get
this data from your cable operator or find it
in forums on the Internet.
4 Start the scan with »
– T he »Search Results« menu appears, and
the search for TV channels begins.
– D epending on the number of television
channels received, this can easily take a
few minutes.
– T he scan is complete as soon as the »PRO-
GRAM TABLE« appears.
Note:
You can abort the scan by pressing »
7
i
5 Press »
« to end the setting.
« or
V
« or »
«. Se-
V
Λ
« (green).
i
«.
15
ENGLISH
Advertisement
Table of Contents
