Setting The Bass Control; Setting The Treble Control - Alpine TDA-7592R Owner's Manual

Setting the Bass Control

You can change the Bass Frequency emphasis to
create your own tonal preference.
1
Press the CENTER f button to select the BASS
(bass Centre frequency) control mode.
→ BASS → TREBLE → OFF
2-1
Setting the bass Centre frequency:
Press the g DN or f UP button to select
the desired bass centre frequency.
→ 60Hz → 70Hz
180Hz ← 150Hz ← 130Hz ← 100Hz ←
Emphasizes the displayed Bass frequency
ranges.
2-2
Setting the bass Band Width (Q-Factor):
Press the BAND button to select the desired
bass Band Width.
→ B.Width1 → B.Width2→ B.Width3 → B.Width4
...........................
(Wide)←
Changes the bass boost band width to narrow or
wide. A wide setting will boost a wide range of
frequencies above and below the centre
frequency. A narrower setting will boost only
frequencies near the centre frequency.
2-3
Setting the bass Level:
Rotate the MODE (Audio Control) knob to select
the desired bass Level (-7~+7).
You can emphasize or weaken the bass
frequency.
NOTES
• If no buttons are pressed within 5 seconds, the Bass
control setting will be turned off automatically.
• The settings of the Bass will be individually
memorized for each source (FM, MW (LW), Tape and
CD changer) until the setting is changed. Depending
on the connected devices, some functions and display
indications do not work.
→ 80Hz → 90Hz
→(Narrow)

Setting the Treble Control

You can change the Treble Frequency emphasis
to create your own tonal preference.
1
Press the CENTER f button select on the
TREBLE (treble Centre frequency) control mode.
→ BASS → TREBLE → OFF
2-1
Setting the treble Centre frequency:
Press g DN or f UP button to select the
desired treble centre frequency.
→ 10.0kHz → 12.5kHz → 15.0kHz → 17.5kHz
Emphasizes the displayed Treble frequency
ranges.
2-2
Setting the treble Level:
Rotate the MODE (Audio Control) knob to select
the desired Treble Level (-7~+7).
You can emphasize the treble frequency.
NOTES
• If no buttons are pressed within 5 seconds, the Treble
control setting will be turned off automatically.
• The settings of the Treble will be individually
memorized for each source (FM, MW (LW), Tape and
CD changer) until the setting is changed. Depending
on the connected devices, some functions and display
indications do not work.
Basic
9
-EN