Setting The Bass Forward; Defeat; Demonstration - Alpine TDA-7592R Owner's Manual

Basic
g DN
f UP
B-FWD/DEFEAT
Basic Operation

Setting the Bass Forward

The Bass Forward function shifts the low
frequency's energy component to the front. This
moves the high energy, dynamic bass sound to
the front sound stage.
1
Press the B-FWD button to activate the Bass
Forward setting mode.
2
Press the DN g button or f UP button to
select the Bass Forward level.
OFF ← → 1 ← → 2 ← → 3
(Less ← .... → More)
NOTE
If no buttons are pressed within 5 seconds, the setup
menu returns to the normal audio display.

Defeat

By setting Defeat ON, all previously adjusted
settings will return to the factory defaults.
1
Press the DEFEAT button for more than 3
seconds to turn Defeat on.
To cancel Defeat, press the DEFEAT button
again for more than 3 seconds.
10
-EN
TUNE DISP
X-OVER SETUP

Demonstration

This unit has the Demonstration feature which
simulates the display functions on the display panel.
1
Press and hold the SETUP button for at least 3
seconds.
2
Press the f UP button to select the "DEMO"
mode. Each press changes the modes as
shown:
→ FM-LV → REG → PTY31 → HI-FI/NORMAL/STABLE → AMBER
DEMO ← AUX ← SCR ← MUTE ← BEEP ← SUB ← DIM ←
NOTE
If you press the g DN button the display scrolls in
reverse sequence.
3
Press the TUNE button to turn on or off the
DEMO mode.
Each press toggles between "DEMO ON" and
"DEMO OFF."
If no buttons are pressed 30 seconds after the
DEMO mode is turned ON. The DEMO mode
then begins.
NOTE
The initial setting at the factory is "DEMO ON."
4
Press the SETUP button again to return to
normal operation.