Dimmer Control; Subwoofer On And Off; Sound (Beep) Guide Function - Alpine TDA-7592R Owner's Manual

Dimmer Control

Set the DIMMER control to AUTO to decrease the
illumination brightness of the unit with the head
lights of the vehicle ON. This mode is useful if you
feel the unit's backlighting is too bright at night.
1
Press and hold the SETUP button for at least 3
seconds.
2
Press the f UP button repeatedly to select
"DIM."
Each press of the f UP button scrolls the
modes as shown:
→ FM-LV → REG → PTY31 → HI-FI/NORMAL/STABLE → AMBER
DEMO ← AUX ← SCR ← MUTE ← BEEP ← SUB ← DIM ←
NOTE
If you press the g DN button the display scrolls in
reverse sequence.
3
Press the TUNE button to select the Dimmer
mode.
Each press toggles between "DIM AUTO" and
"DIM MANU."
4
Press the SETUP button to activate the normal
mode.

Subwoofer On and Off

1
Press and hold the SETUP button for at least 3
seconds.
2
Press the f UP button repeatedly to select
"SUB (Subwoofer)."
Each press of the f UP button changes the
modes as shown:
→ FM-LV → REG → PTY31 → HI-FI/NORMAL/STABLE → AMBER
DEMO ← AUX ← SCR ← MUTE ← BEEP ← SUB ← DIM ←
NOTE
If you press the g DN button the display scrolls in
reverse sequence.
3
Press the TUNE button to toggle mode between
"SUB-W ON" and "SUBW OFF."
4
Press the SETUP button after setting the SUB-W
ON.
5
Press the MODE (Audio Control) knob
repeatedly to select the SUB-W mode.
→ SUB-W
VOL ←
If an Ai-NET compatible processor with
Subwoofer output is connected:
The subwoofer output phase is toggled SUBW
NOR (0°) or SUBW REV (180°) by pressing the
g DN button or the f UP button.
6
Rotate MODE (Audio Control) knob until the
desired sound is obtained in each mode.

Sound (Beep) Guide Function

This function will give audible feedback with
varying tones depending upon the button pressed.
1
Press and hold the SETUP button for at least 3
seconds.
2
Press the f UP button repeatedly to select
"BEEP."
Each press of the f UP button changes the
modes as shown:
NOTE
If you press the g DN button the display scrolls in
reverse sequence.
→ FM-LV → REG → PTY31 → HI-FI/NORMAL/STABLE → AMBER
DEMO ← AUX ← SCR ← MUTE ← BEEP ← SUB ← DIM ←
3
Press the TUNE button to toggle the mode
between "BEEP ON" and "BEEP OFF."
NOTE
The initial setting at the factory is BEEP ON.
4
Press the SETUP button to set the selected
mode.
Basic
→ BAL
FAD ←
7
-EN