Sunbeam MultiMincer FG5600 Instruction And Recipe Booklet page 9

Using your Sunbeam MultiMincer
Fitting and using the Kebbe attachments
1. Place the mincer body, facing you on a
level, dry surface.
2. Fit the mincing screw inside the chute.
3. Fit the kebbe shaper.
4. Fit the kebbe cone over the shaper.
5. Secure the kebbe attachments with
the fastening dial. Loosely secure with
fastening dial – do not use spanner until
chute is locked into mincer body. See
figure 5.
Figure 5
6. Align chute into the mincer body using
arrows as a guide. Press and hold the
lock/unlock button to twist and lock into
place. Use the spanner to tighten the
fastening dial to ensure all elements are
securely in place.
(continued)
®
7. Place the feeder tray on top of the chute.
See Fig 6.
8. Plug the power cord into a 230-240V AC
power outlet and turn the power 'ON'.
9. Switch on mincer.
10. Using the pusher, push the kebbe mixture
into the chute.
11. Cut kebbe into desired lengths.
Tip: For full kebbe recipe and suggestions see
page 20.
Figure 6
9