Optional Hose Position
Fluid inlet swivels and air quick disconnect fitting point to
rear. If desired, these positions can be changed so
hoses travel downward.
CAUTION
To prevent cross-contamination of gun's wetted parts,
do not interchange A component (isocyanate) and B
component (resin) parts.
1.
Follow Pressure Relief Procedure, page 15. Also
relieve system pressure, see proportioner manual.
2.
Disconnect air (D) and remove fluid manifold (M).
M
3.
Disconnect fluid hoses from inlet swivels (A, B).
Remove swivels. Remove plugs from optional
inlets (P).
B
309550U
D
TI2554A
A
P
TI2417A
4.
Apply thread sealant to plugs (12c), elbows (50*),
and male threads of swivels (A, B). Install elbows
(50*) in optional inlets (P), facing down. Install
swivels (A, B) in elbows. Be sure to install A swivel
(smaller) in A side. Install plugs where swivels had
been. Torque all parts to 235-245 in-lb (26.6-27.7
N•m).
Elbows (50*) are not included with spatter spray
gun.
B
5.
Connect A and B hoses to A and B swivels.
6.
Remove fitting (D) and plug (J). Reverse positions.
Apply thread sealant and torque to 125-135 in-lb
(14-15 N•m).
7.
Attach fluid manifold. Connect air. Return gun to
service.
Optional Configurations
12c
50*
A
P
TI2646A
D
TI2540A
J
17