Installation And Removal; Installing The Car Radio, The Mounting Frame And The Aerial; Fuse; Supply Voltages - Grundig WKC 3300 RDS User Manual

Installation and Removal

The Figures to installation and removal are to
be found at the beginning of this booklet.
Installation materials and accessories
Your dealer can advise you as to what instal-
lation materials you will need and what acces-
sories are available.
Installing the mounting frame
o
Figure
– Insert mounting frame b into cutout a of the
vehicle.
– Bend the tabs c behind cutout a as required
(depending on type of vehicle).
Inserting the car radio
o
Figure
– Insert the car radio all the way into the
installed mounting frame b.
The car radio should snap into place.
Your car radio is a device of high power.
That is why it can get hot during operati-
on.
For this reason, make sure that leads or
other parts cannot touch the radio, as this
might cause the insulations to melt resul-
ting in a short circuit and even in fire.
Removing the car radio
a
Figure
Before removing the car radio, please
o a
remove the control unit to prevent it from
...
being scratched.
Insert the two removal handles d as far as
possible into the openings in the trim.
– Press both removal handles outwards and
slowly pull the radio out.
Aerial
The car radio is designed for aerials with an
impedance of 75 Ω to 150 Ω. Extended aerial
cables, e.g. for aerials at the rear of the car,
may impair reception.
p ü
Figures and
– If necessary, use the aerial adapter (fig.
– Fix the aerial adapter (fig.
ü
(fig. ) in the plastic holder.
Fuse 10 A
Figure
Blade-type fuse 10 A/ DIN 72581 – plugged.

Supply voltages

Blade contacts A: Figure
A8
Connect to terminal 31 (earth) of the vehicle.
A7
Connect to terminal 30 (permanent plus) of
the vehicle.
A6
Connect the blade contact A6 to terminal 58
of the vehicle.
When the vehicle's headlights are switched
on, the illumination of the switched off car
radio can be adjusted with the instument illu-
mination control.
Blade contact A6 not connected:
No illumination when the radio is switched
off.
p
).
p
) or aerial cable * If the leads in the vehicle have not a sufficient
cross-section, the maximum output power of
the car radio may be reduced and the radio
illumination may fluctuate.
19
+
+
Earth connection*
+12 V operating voltage*
Car radio illumination
GB