Keep the card in a safe place, out of reach The control unit unlocks and can be removed. dows. of unauthorized persons. – Remove the control unit. GRUNDIG environment initiative You must have noticed that we have completely dispensed with plastics in the packing material for this car radio.
Switching On and Off Please note The car radio can be switched on and off at Refitting the control unit any time. ¡ To do this, press the button. Insert the control unit into the instrument cut- out so that it locks into place. Switching on and off with the ignition switch of the vehicle.
Volume and Sound Settings Example: Bass Volume ¢ ¢ Press the button until two sound sig- SOUND ¢ ¢ nals are heard. The display indicates Repeatedly and briefly press the SOUND Use the r t buttons to adjust the VOLUME "LOUD ON"...
Radio (Tuner) Selecting a range Traffic announcement standby (TP) Alternative frequencies (AF) FM range: Repeatedly and briefly press the TP (TRAFFIC PROGRAM) =. stations broad- When receiving a DSR programme which is ¢ ¢ button until the display indicates casting traffic announcements. broadcast by several stations on different fre- RADIO "FM I"...
Radio The station search function is described on Setting RDS programmes If no reception is possible (e.g. in an page 7. (IS function) underground car park, or when the aerial is defective), the search function may be Station buttons ¢ ¢ ¢...
Radio 2. Briefly press one of the r Calling up stored stations/RDS programmes: TUNING If the pressed r t button is held buttons to start the station search in the TUNING Select the range: FMl, FMll, MW or LW. down, tuning is effected at high speed. desired direction.
Cassette (TAPE) í General notes Please always eject the cassette by pres- While a cassette is wound forward, you can “ sing the button before switching listen to the radio or play a CD. For this, The unit is optimized for CR (chromium off the radio.
Installation and Removal The Figures to installation and removal are to Removing the car radio Fuse 5 A be found at the beginning of this booklet. Figure Figure í Blade-type fuse 5 A/ DIN 72 581 – plugged. Installation materials and accessories Before removing the car radio, please remove the control unit to prevent it from Your dealer can advise you as to what instal-...
Installation and Removal +12 V switching voltage output Loudspeakers (max. 0.5 A) on blade contact A 5 when the radio is Blade contacts B: Figure switched on. Maximum output power For automatic aerial (extend/retract), with 4 Ω loudspeakers: 4 x 7 W. aerial amplifier (operating voltage) etc.
Therefore use only stations, each with a different broadcast In the Federal Republic of Germany, Grundig high-quality heat-resistant C60 and C90 CrO frequency (alternative frequencies). car radios can be exchanged by your dealer cassettes from name-brand manufacturers.
Troubleshooting The radio cannot be switched on Poor reception One ore more loudspeakers are dead Insert the control unit once again. Are you in an area of bad reception conditions Check the setting of the FADER and BALANCE (eg., underground car park, tunnel, valley, controls and correct if necessary.
Page 15
Identity Card e Adesivi di segnalazione DECLARACION DE CONFORMIDAD CON NORMAS seal on the unit is the precondition for your (vedere pagina 2) El que suscribe, en nombre de GRUNDIG AG, guarantee. Kurgartenstraße 37, D-90762 Fürth, RFA. Identity Card et Autocollants de code...