ZyXEL Communications VMG4380-B10A User Manual page 106

Chapter 7 Wireless
In order to configure and enable WEP encryption, click Network Setting > Wireless to display the
General screen, then select Basic as the security level.
Figure 32 Wireless > General: Basic (WEP)
The following table describes the labels in this screen.
Table 18 Wireless > General: Basic (WEP)
LABEL
Security Level
Generate
password
automatically
Password 1~4
more.../less
WEP Encryption
106
DESCRIPTION
Select Basic to enable WEP data encryption.
Select this option to have the Device automatically generate a password. The password field
will not be configurable when you select this option.
The password (WEP keys) are used to encrypt data. Both the Device and the wireless
stations must use the same password (WEP key) for data transmission.
If you chose 64-bit WEP, then enter any 5 ASCII characters or 10 hexadecimal characters
("0-9", "A-F").
If you chose 128-bit WEP, then enter 13 ASCII characters or 26 hexadecimal characters
("0-9", "A-F").
You must configure at least one password, only one password can be activated at any one
time. The default password is Passowrd 1.
Click more... to show more fields in this section. Click less to hide them.
Select 64-bits or 128-bits.
This dictates the length of the security key that the network is going to use.
VMG4380-B10A / VMG4325-B10A User's Guide