Tcp/Ip Printing In Windows 95 , 98, Nt And 2000 - Axis 5600+ User Manual

Section 4: Setting Up - Windows
36
Client-Server Printing

TCP/IP Printing in Windows 95 , 98, NT and 2000

Set the print server's
IP address
Add a printer to 'My
AXIS Print System needs only to be installed on one server to perform
client-server printing. The installed printers must be configured to be
shared to allow clients to use them. Pop-up messages should not be
enabled on the server, as they will not be displayed on the client
platforms.
Install AXIS Print System ver. 1.20 on your Windows 95, 98, NT or
2000 client, if you have not already done so. This software can be
downloaded from the AXIS Product CD or from the Axis web
http://www.axis.com. To enable printing in the TCP/IP
environment, you must ensure that the TCP/IP protocol is enabled on
your client.
See Assigning an IP address, on page 23.
The network printers and Axis print servers that are available in your
network are displayed in the Available Printers/Print Servers window.
Printers'
Only printers connected to Axis print servers with firmware versions
6.00 or higher will appear in the Available Printers/Print Servers
window.
Follow these instructions to add a network printer to My Printers:
1. Select the Available Printers/Print Servers tab.
2. Select the network printer you wish to add to your My Printer list
and click the Add to My Printers button or select Add (Typical)
to My Printers from the Printer menu. The AXIS Print System
Add Printer Wizard will start. Follow the instructions given on
the screen in order to install an appropriate driver.
AXIS 5600+ User's Manual