Axis 5600+ User Manual page 30

Section 3: Basic Installation
30
Setting the print
server's IP address
using ARP in UNIX
Follow the instructions below to set the IP address using ARP:
Type the following commands in the shell window:
arp -s <host name> <Ethernet address> temp
ping <host name>
Example:
arp -s npsname 00:40:8c:10:00:86 temp
ping npsname
The host will return
indicates that the address has been set and that communication is
established.
Notes: If the host name has not been mapped to an IP address, simply
replace the host name entry with the IP address in the example
above.
The ARP command varies between different UNIX systems.
Some BSD type systems expect the host name and node address in
reverse order. Furthermore IBM AIX systems will require the
additional argument ether. For example:
arp -s ether <host name> 00:40:8c:10:00:86 temp
When you execute the
experience a significantly longer response time than is usual.
AXIS 5600+ User's Manual
npsname is alive,
command for the first time, you may
ping
or a similar message. This