Ptz Control - Genie 4CH User Manual

【Channel】Select the connect channel of camera;
【Protocol type】Select the corresponding brand model protocol of speed dome camera;
【Address】Setting the corresponding ID of speed dome camera;
Caution; the ID and protocol setting of DVR should fit for the speed dome camera, other wise, you can not control the speed dome camera
through RS-485 of DVR;
【Baud rate】Select the corresponding baud rate of speed dome camera, can control to the corresponding channel PTZ and camera, the default
setting is 9600;
【Data bit】Default is 8;
【Stop bit】Default is 1;
【examination】Default is None;
【Flow-control】Default is None;
PTZ setting should be saved in everyone channel after setting.

3.8.3 PTZ control

To control the 【direction】 , 【 speed】 , 【 aperture】 , 【 focus】 , 【 Iris】 , 【 cruise control】 , 【 cruising setting】 , 【 scan boundary】 , 【 back light Compensation】 ,
【auto scan】Of PTZ, coordinate with the direct key during setting;
There are two different kind of control interface in PTZ control, in preview mode, click right key of mouse in everyone channel, the shortcut menu will
popping the "PTZ Control" selection as follows.
【Assist On/Off】Can call the user-defined assist function, for example, lighting, windshield wiper etc;
【Preset setting】Preset point setting;
【Call preset】Call the preset point setting;
The function call display menu interface in【Main menu】
The setting of pan driver step length through the inferior level slid bard of direction key to adjust. Major for neck rein operation, the step length is
more and more longer then the rotational speed follows;
Direct to single click the key of
【PTZ control】 as follows;
, of zoom, focus, IRIS, adjustment for zoom, definition, illumination.
38