Powering On; Boot-Strap - Genie 4CH User Manual

3 Double click left button
4 Dragging the mouse

3.2 Powering On

3.2.1 Boot-strap

If【POWER】pilot lamp off, please follow the operation step by step:
First step: if the power does not plug into, please plug into the power, then the DVR-4108 begin to start, by now, if the DVR-4108 still inactive, to
enter the next step;
Second step: turn on the power supply of the DVR-4108 at the back panel, DVR begins to start.
If【POWER】pilot lamp to offer RED, press the 【POWER】key, DVR-4108 begins to start.
The video output mode of DVR-4108's the default setting is multi picture channel mode after starting the DVR-4108, if the time of start the
DVR-4108 is in the Timing Recording Setting, the DVR-4108 will automatically to start the Timing Recording function, the corresponding channel's
recording pilot lamp will be light, the DVR-4108 is normal operation.
If you do not install the hard disk drive in the DVR-4108 before turn on the power, after Login the system, the system will call attention to as follows;
To run the ActiveX Control ActiveX special operation, For example, double click the
certain item of record listed file, then the system will playback the segment
record video.
Depress the left key and dragging the mouse, banding select Motion detection area,
depress right key of mouse and Dragging, cancel the banding select area.
Dragging playback ProgressBar back and forth to dolly moves, to achieve the playback
position adjustment. Dragging the audio and video regulation parameter bar dolly moves,
to achieve the parameter adjustment.
22