Control With Mouse; Connect Mouse; Use Mouse - Genie WHDSDI16 User Manual

Table of Contents

However when controlling multiple DVRs with multiple remote controllers, you would need to configure the device ID, please refer to

below steps:

 Activate remote controller to control the DVR: Turn the IR sensor of the remote controller towards the IR receiver on the front panel,

press the number key 8 twice on the remote, then input device ID of the DVR to be controlled (Range from: 0-65535; the default device

ID is 0) and press ENTER to confirm.

 You can check the device ID of a DVR from System SetupBasicDevice ID. You can also set multiple DVRs with the same device ID

however this can cause interference if the DVRs are kept close to each other.

2.5 Control with Mouse

It supports USB mouse through the ports on the rear panel.

Notice: If mouse is not detected or doesn't work, check below steps:

1. Make sure the mouse is plugged in the USB mouse port, and not the USB port on the front panel.

2. Try with a good known mouse (not a cheap one!).

During live:

Double-click on any camera window for the full screen mode. Double-click again to return to the previous screen mode.

Right click to reveal the control menu on the screen. Right click to hide the control menu.

In Configuration:

Click to enter a particular option. Right click to cancel the option or to return to the previous menu.

In order to input a value in a particular screen, move cursor to the input box and click. An input window will appear as Fig 2-7. It supports

digits, alphabets and symbols as inputs. Click Shift button to input Capital letters and symbols; click Shift button again to return.

You can change some values using the mouse wheel, such as time. Move cursor onto the value and roll the wheel when the value blinks.

DVR User Manual

Table of Contents