Table of Contents
Advertisement
Wireless Broadband Router
4.4 Wireless
The WRT-416 implements Access Point capability, which connects wireless clients to a wired LAN. It allows
wireless stations to access network resources and share the broadband Internet connection.
4.4.1 Basic Settings
Radio Band: The default setting is mixed mode [802.11B/G]. If you do not know or have both 11g and
11b devices in your network, then keep the default in mixed mode. From the drop-down manual, you
can select 802.11G if you have only 11G card. If you have only 802.11 B card, then select 802.11B.
Radio Mode: The Route has 3 modes: AP, WDS, AP+WDS. If WDS or AP+WDS is selected, please go
to WDS tab to complete related settings.
Booster Mode: Enabled this mode can enhance the throughput of data transmission.
SSID: The SSID is the network name shared among all points in a wireless network. The SSID must be
identical for all devices in the wireless network. It is case-sensitive and must not exceed 32 characters
(use any of the characters on the keyboard). Make sure this setting is the same for all points in your
wireless network. For added security, you should change the default SSID (default) to a unique name.
Channel: Select the channel used for wireless communication. There are 11 overlapping channels.
Channels 1, 6 and 11are non-overlapping. The default is channel 6.
Click "Apply" when you have finished the configuration above.
Please setup authentication and Encryption mode to setup Valid and Safe wireless connection after setting
Basic Wireless parameters.
Page 30 of 47
User manual
Advertisement
Table of Contents
