Autoreverse; Dolby Nr; Changing The Audio Source With Src; Care Of Your Audio Equipment - Blaupunkt MADEIRA RCR 85 Operating Instructions Manual

Autoreverse

If, while a tape is playing, you wish to switch
to the other track of that tape:
• press FR and FF simultaneously.
At the end of the tape, the set will automati-
cally switch to the other track. The display will
show "TR1-PLAY" for track 1 or A and "TR2-
PLAY" for track 2 or B.
Note:
If there is too much tension on the tape during
playback, the set may switch to the other
track by itself. In this case check the condition
of the tape. Sometimes it helps to rewind the
cassette tape completely.

Dolby NR*

With this set you can play cassettes recorded
with or without Dolby NR noise reduction.
Cassettes recorded with Dolby NR* distin-
guish by their reduced background noise and
the improved dynamic characteristics.
To switch Dolby on/off:
• press . When Dolby is on, " " is indi-
cated on the display.
* Noise reduction system manufactured under license
from Dolby Laboratories. "Dolby" and the double-D
symbol are trademarks of Dolby Laboratories.
26
Changing the audio source
with SRC
When you have inserted a cassette, you can
change between tape or radio reproduction.
To switch over,
• press the SRC button.

Care of your audio equipment

We recommend that you use only C-60/C-90
cassette tapes in your car radio. Protect your
cassettes from dirt, dust and temperatures
exceeding 50 C. During cold weather, allow
cold cassettes to warm up somewhat before
playing them in order to avoid uneven tape
transport. Operating problems and sound
distortions may occur after approximately
100 hours of playing time and are caused by
dust particles which adhere to the rubber
roller and the audio head.
Use a cleaner cassette to remove normal dirt
build-up. For tougher cases, use a cotton
swab (Q-tip) soaked with alcohol. Never use
any hard tools to clean your unit!

DSC programming

This car radio offers direct software control
(DSC) to adjust a number of default settings
to your personal needs and store them.
Listed below you will find an overview of such
default settings.
To change a setting,
• press DSC.
Then use the rocker switch to select the
functions described in the following and chan-
ge the respective value. The current conditi-
on is indicated on the display.
Select function
Change
+
setting
Select function
LOCAL Seek tuning sensitivity for
(lo) local reception
LOCAL 1 - high sensitivity
LOCAL 3 - low sensitivity
Change
setting