Contents Radio operation with RDS ... 20 Tape operation ......24 Short description ......16 AF - Alternative Frequency ....20 Inserting a tape ........24 Important information ....18 REG - Regional ........20 Ejecting a tape ........24 What you need to know! .......
Short description 2 Rocker switch 5 Fast winding of the tape/ 1 Amplifier autoreverse Seek tuning Changing the track Volume Press simultaneously Scan: Press for 1 second TR1-PLAY or TR2-PLAY in the display Fast rewind Fast forward down in up in To stop: To stop: short steps...
Page 5
7 1, 2, 3, 4, 5, 6 - preset buttons 9 lo; dx = TS (Travelstore) You can store 6 stations on each FM Seek tuning sensitivity To store the six most powerful nearby memory bank (I, II, III and T). lo lit up in the display indicates normal stations automatically with Travelstore.
Only use the accessory and replacement It should not be possible for thieves to ascer- moving at a speed of 14 m per seconds. parts approved by Blaupunkt. tain the code number by trial-and-error. This It is also very important that you are able to...
• Enter the code number given in the The radio must be connected to permanent - Press preset button 2 five times, Blaupunkt car radio passport and con- power. “2500” appears in the display. firm: See example “Restart following In order to switch the code system on: - Press preset button 3 twice, “2520”...
Radio operation with RDS Selecting a station An ever increasing number of FM radio sta- “SEARCH” goes out as soon as the system tions broadcast addition information in paral- has found an alternative frequency or after FM radio stations in the range between lel to their normal program via the Radio Data the frequency band has been scanned com- 87.5 and 108 MHz can be received.
Adjusting the seek tuning sensi- Changing the memory bank (FM) Note: tivity If you tune into a station which has already You can shift between the memory banks I, II been stored on another memory bank, the Two basic levels can be selected for the seek and III to store and recall preset stations.
Recalling stored stations Sampling stations briefly with Radio Scan You can recall any stored station by pressing the corresponding preset button. This function allow you to sample the subse- quent stations briefly for approximately 8 se- • Use the FM or TS button to select the conds each.
Reception of traffic announcements with RDS-EON Priority of traffic announcements Automatic seek tuning start Many FM broadcasters provide their service ON/OFF (During cassette operation) area with traffic messages at regular inter- vals. “TA” lights up in the display, if the priority of If you leave the reception area of your traffic All traffic program stations transmit a special traffic announcements is on.
Tape operation Fast winding Autoreverse Inserting a tape Fast forward • Press FR and FF at the same time. • Turn the set on. • Press FF (fast forward). At the end of the tape, the unit will automati- • Insert a tape.
DSC programming Care of your audio equipment This car radio offers direct software control LOCAL To adjust the tuning sensitivity (DSC) to adjust a number of default settings for local reception It is advisable to only use C-60/C-90 tapes in to your personal needs and store them.
Appendix ARI (TA) To adjust the volume of traffic Technical data announcements between 1 Amplifier and 9. Output power: 4 x 6 W RMS power ac- cording to DIN 45324/3.1 CODE-LED To select the LED mode for into 4 Ω optical theft protection.