Wheels; General; Oil Lubricated Front Wheel Bearings; Normal Maintenance - Ford F-750 Owner's Manual

2007
Hide thumbs Also See for F-750:
Table of Contents

Advertisement

Maintenance and Specifications
4. Clean any dirt from around the rear axle filler and drain plugs.
5. Remove the filler and drain plugs and drain the lubricant into a
suitable container. Dispose of all used automotive fluids in a responsible
manner following your local authorized standards.
6. Clean and install the drain plug securely.
7. Add enough lubricant through the filler plug opening so that the
lubricant level is up to the bottom of the opening.
8. Clean and install the filler plug securely.

WHEELS

General

Wheel bearings should be inspected, lubricated and adjusted at regular
intervals. This is especially important if operating in deep sand, mud, or
water. Refer to Lubricant specifications in this chapter.
When installing wheel balance weights, they must be mounted on the
dome-side of the wheel only. Failure to do so may result in loss of wheel
weight and/or damage to brakes or wheels.
Important: Remember to replace the wheel air valves when the road
tires are replaced at the end of their useful life.

Oil lubricated front wheel bearings

During normal vehicle duty cycle, the lube and air inside the hub/wheel
cavity expands and if not vented, causes pressure build-up that could
cause accelerated seal wear.
There are two venting methods:
• a slit or small hole in the rubber check vent or
• the window
You can use either of these methods to prevent pressure build-up.

Normal maintenance

Over a period of time, if not routinely cleaned, a slight film of oil can
collect dirt around the rubber fill plug and face, which could appear to
be a leak. Routine cleaning ensures that the lube level can be easily
observed through the clear window as intended. In situations where the
window is clean on the outside but discolored on the inside, the lube
level may be checked by inserting a finger through the rubber check
vent hole.
The specified lube level for a clear window type hubcaps is from the
minimum line to + 5/16 inch above the minimum line.
204
2007 F-650/750 (f67)
Supplement (supplement)
Canadian_French (fr_can)

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

F-6502007 f-7502007 f-650

Table of Contents